Uteco Horizon D/TH model 130 Laminating

Condition Used (visible in production)
Film width max. 1350 mm (53”)
Coating width: max. 1300 mm (51")
Mechanical speed 1000 fpm (305 m/min)
Production speed The production speed depends on the following conditions: - type of material; - type of glue; - required quality, etc
Materials to be coated BOPP 18-40μ | PA 12-30μ | PET 12-24 μ | PAPER 60-100gr/m2 | LAMINATES 60-100gr/m2
Materials to be laminated BOPP 12-40μ | CPP 12-40μ | PA 12-30μ | CPA 12-30μ | LDPE 20-120μ | PET 12-24μ | ALU FOIL 9-18 μ | PAPER 40-80gr/m2 | LAMINATES 40-80gr/m2
First unwinder reel diameter 800 mm
Secondary unwinder reel diameter 800 mm
Rewinder diameter 800 mm
Cores Inside diameter 76 mm (3”)
Expansible Pnematic Adaptors Inside diameter 152 mm (6”)
Reel shafts pneumatic
Materials sequence from left to right
Type of job dry coated | rotogravure lacquering
plant voltage supply 480 V +/- 5%
Power supply 400 V +/- 10% 3 phase
Main line frequency 60 Hz +/- 2%

Compressed air supply:
Non-lubricated, dried and filtered
Pressure: 6 bar (86 PSI)
Dew point: + 2°C (36°F)

Chilled water specification:
Filtration clarity: less than 20 μ
Pressure: min. 2 bar (29 PSI) max.3 bar (44 PSI)
Inlet temperature (chilled rolls, with room temperature 20°C (68°F)): 15°C to 18°C 59°F to 65°F
Hardness (Ca CO3): 2.5 to 4 mg/lt 2.5 to 4 ppm | pH: 7 to 8.2