Sterling 66" wide Sheet line

Sterling sheet extrusion line consisting of the following:
4.5" Sterling 36:1 L/D single screw extruder driven by a
200 HP DC motor with SCR control. Extruder has 78" centerline.
Previously used extruding horizontally into
chill roll chrome nip roll.
Extruder is double vented (1 vent presently plugged) and
includes vacuum system and closed loop
water cooling system for barrel heat/cool.
Includes (2) spare screws.

4.5" Sterling hydraulic plate screen changer with
hydraulic power pack.
15 HP Luwa mill pump.

(2) sheet extrusion dies as follows:
- 66" Johnson flex lip sheet die with 45 degree restrictor bar and
removable lower lip supplying .001 through .250" gap.
- 60" EDI H75 sheet extrusion die for .001 through .075" gap.

66" wide Sterling sheet cooling roll take off with
(4) cooling/polishing rolls mounted in a cast line configuration.

Extruder therefore extrudes downward into
(2) 8" diameter chrome rolls which then "S" wraps through
(2) 14" diameter chrome rolls.
All chrome/polishing rolls are individually driven by
a DC motor with SCR controls.

Has idler roll conveyor and (2) rubber pull roll haul off.
Includes spare chrome/polishing rolls as follows:
- (2) 8" diameter and (2) 14" diameter
(2) dual zone oil temperature control units
(4 zones total) for use with chrome/polishing rolls.

Wysong 72" shear model 1272.
Sheet stacker for use with shear for
automatic stacking of extruded cut sheets.

Equipment reported completely rewired and
some items rebuilt and used sparingly after rebuilding.