Roundo Angle Bending Rolls

8" x 8" x 1-1/4" ROUNDO Angle Bending Rolls, For Large I-Beams, 108 HP
AGE: 1996

TEMPORARY SPECIFICATIONS:
For Large I-Beams
Capacity, Angle Bend, Leg Out 60": 8" x 8" x 1-1/4"
Capacity, Angle Bend, Leg In 50": 3" x 3" x 1/4"
T-Section, Leg Out 50"/Leg In 60"/Leg Down 50": WT 8" - 3"
Flat Bar On Flat Hard Way 120": 16" x 2-3/8"
Flat Bar On Flat Hard Way 80": 12" x 3-1/2"
Flat Bar On Flat Hard Way 60": 3" x 1/2"
Flat Bar On Flat Easy 70": 22" x 4"
Square 100" / Square Tube: 8" x 8" / 16" x 16-5/8"
Round Bar 80" / Pipe Schedule 40: 10-1/2" / 20"
S & WF Beams 200": W 36" x 210#
WF Beams 200": W 33" x 241#
WF Beams 150": W 30" x 211#
Channel In & Out, 60": MC 18" x 58# C 6"
Beam On X-X Axis, 1,800": W 24" x 117# W 6"
Channel On X-X Axis, 700": MC 16" x 58# C 6"
Diameter Of Bending Rolls: 32"

EQUIPPED WITH:
Beam Puller
Hydraulically Controlled Guide Rolls, Up / Down / In & Out
Large Selection Of Spacers For Beam On Edge, Channels, Bars
And Tubing
Full Pendant Control
Oversized Shaft, Motors & Drive (Normally Found On R-15-S)
Standard Set Of Angle / Bar Rolling Dies
Set Of Square / Rectangle Tubing Dies, Reversible For 3/8"
& 1/2" Wall
Power In-Feed Rolls, 12" Diameter x 3/4" Wall
Portable Hydraulic Support Roll Stand
(7) Sets Of Pipe Rolls: 8", 10", 12", 14", 16", 18" & 20"
TOOLING: Roughly $750,000 Of Tooling Included