RCM Hot Dispersion System

Raw material: corrugator trims
4 x vertical thickening presses type PV-230
To thicken pulp out of cleaning phase

With following characteristics:
material: waste paper
pulp density in: 3-4%
pulp density out: 10-12%
absorbed power: 4,5 KW each
installed power: 5,5 KW each
screw speed: 63 rpm
motor speed: 1450 rpm
basket holes Ø: 2 mm
body in AISI 304; screw in AISI 304
baskets AISI 304 with conic holes, complete with reinforcing rings in AISI 304
shaft in AISI 304; oil lubricated bearings

Complete with:
speed reductor
elastic joint to connect speed reductor and screw
stainless steel support for the 4 presses
Stainless steel screw (left-right)
With open box, complete with pulleys, belts, belts protection and 2,2 KW motor reductor, 50 Hz
Horizontal press type PO-500
To thicken pulp out of vertical presses

With following characteristics:
material: waste paper
pulp density in: 10-12%
pulp density out: 30%
absorbed power: 50 KW
installed power: 75 KW
screw speed: 35 rpm
motor speed: 1450 rpm
basket holes Ø: 2 mm
body in AISI 304, screw in AISI 304 high thickness,
basket with external holes in AISI 304 high thickness,
changeable basket with internal holes in AISI 304 with conical holes,
basket on the screw in AISI 304 with conical holes for internal drainage
pneumatic group on the final part of the screw, to regulate thickness of pulp density outcome

Complete with:
elastic joint to connect press and reductor
speed reductor
elastic joint to connect speed reductor and electric motor
stainless stell joints protections
stainless steel basement for the press, complete of AISI 304 vat water recovery
stainless steel basement to connect speed reductor and electric motor
Electric motor must be driven by an inverter
Heating horizontal tunnel type TL-800
To heat pulp coming out of horizontal press