Okuma OSP P300L Control 6000 RPM Genos L3000MYWe 4 Axis

Okuma Genos L3000MYWe
2019

Swing over Bed: 20.47″
Swing over Saddle: 9.06″
Max Recommended Turning Diameter: 15.35″
Max Recommended Turning Length with Std Chuck(s): 13.74″
Travel, X-Axis: 9.25″
Travel, Y-Axis: 3.94″ (+/-1.97″)
Travel, Z-Axis: 18.11″
Travel, W-Axis (Sub-Spindle) 20.47″
Main Spindle
Spindle nose A2-8
25-3000 RPM, 2 speed by coil, Belt Drive
20/15 HP, 420/308 ft.-lbs torque, 30 min/continuous
Spindle bore 3.15”
Drawtube ID 2.75”
Sub-Spindle
Spindle nose 140mm Flat Nose
Spindle Speed 100-6000 RPM range
Spindle Motor 10/7.5 HP, 35/26 ft.-lbs torque, 30 min/continuous
Spindle bore 2.08”
Drawtube ID (partial), Solid Actuator 1.69”
Turret
12 Station Turret
0.1 Seconds per Station Index
6000 RPM Live Tool Drive
7.5 / 5 HP, 23 / 15.4 lb.-f torque (2 min / continuous)
Rapid Travel IPM X-Axis: 787
Rapid Travel IPM Y-Axis: 394
Rapid Travel IPM Z-Axis: 984
Rapid Travel IPM W-Axis: 984
Power Requirement, 220 Volts, kVA without Optional Equipment 26.5
Floor Space Required W x D x H (without Chip Conveyor) 128″ x 72″ x 73″
Weight (lbs): 11976

Equipped With:
OSP P300L Control
Y-Axis
Sub Spindle
Tool Presetter
Parts Catcher
Chip Conveyor
10” Chuck on Main
6” Chuck on Sub Spindle
(2) Live Holders