Northtech NT-MRS-14 N Miltiblade rip saw

Close link chain vs. open (no dust or pinch point)
Oiler has twice the number of lube points (critical)
The VS adjustment location on the 14N.
Can cut up to 4 15/16″ with 14″ blade vs. the MRS-12 12″ blade 3-15/16”.
* Can run 12″ as well on the MRS-14N*
Bottom kickback fingers for added safety
Saws, with proper tooling and material, can glue line

Specifications :
Main Motor Hp. = 50 Hp.
Voltage/ Freq. = 460 Volt 60Hz
Phase = 3 Phase
Amp Requirement = 35 Amps
Feed Hp. = 2 Speed 1.5 / 3 Hp.
Feed System = Feed Chain
Feed Speed = 25 – 120 FPM
Variable Speed = Variable Speed Pulley
Elevation Hp. = 1/4 Hp.
Elevation Style = Manual Wheel Adjustment
Elevation Sys. = Jack Screw / Linear Guides
Total Hp. = 53.25 Hp.
Electronics = CE Approved Components
Dual Voltage = Elevation Arbor Motors
Control Voltage = 110 Volt
Assisted Start = Wye-Delta
Pass-Line = 33-1/2”
Min. Length = 17-3/4”
Min. Width = 1/2”
Max. Width = 27-1/8”
Min. Thickness = 5/16”
Max. Thickness = 4-15/16”
Arbor Rpm = 3570 Rpm
Blade Size = 12” Tungsten Carbide Tipped
No. of Teeth = 36 Tooth
Blade Kerf = 3.5 mm
Cleaning System = Brush on Chain
Vertical Travel = 3/8” – 5”
Dust Collection = (2) 6” @ 1962 CFM
Arbor Diameter = 70 mm
Hold Down Style = Pressure Plate
Kickback Finger = (2) Top (1) Bottom Sets
Emergency Stop = Push Button
Rear E Stop = Push Button
Safety Feature = Safety Interlock Switch
Guarding = Full Cabinet Enclosure
Oiler = Automatic Mechanical Oiler
Low Oil Warning = Low Oil Shut-off
Fence Type = Adjustable
Fence Dims. = 103” Length
Frame Const. = 5/16” Steel Construction
Worktable Dims. = 27-1/8” x 64”
Infeed Table = 13-3/4” x 103”
Decible Rating = 74 dB
Net Weight = 4402 Lbs.
Gross Weight = 4694 Lbs.
Machine Dims. = 67” x 58” x 71”
Packaging Dims = 72” x 65” x 77”