Mohrbach MB PCT, Cartoner

Possible folding box formats:
92 * 82 * 95mm and 92 * 82 * 75mm
Machine for erecting and gluing boxes from flat blanks, as well as filling the boxes,
Lid shapes and lid closing.
The magazine supply for the cardboard blanks is monitored by 2 photocells. One is used to warn
at minimum cutting and the second, the machine switches to malfunction when only a few are left
There are blanks in the magazine.
A cardboard blank is removed from the inclined magazine by means of a vacuum feeder, into which
Transport guide rails stored and with feed bars horizontally over the folding tool
transported. Here, the blank passes the glue station, where hot glue is applied to the cardboard blank
is applied.
After the blank has been transported over the folding tool, it becomes vertical from the
working push-in ram pushed through the opening of the folding tool. The glued
Cardboard sides are erected around the ram and, thanks to the special shape of the tool jaws, to the
Lateral connecting straps pressed and glued.
The erected and glued box is stripped off below the tool and placed in a
underneath running cycle chain with pushing and counter-holding drivers deposited and to
Filling station transported.
The pyramid bags, pre-packed in a bag, are transported from the side via a belt conveyor
fed, set up and placed in the box using the "toploading" method.
In the following station, the bag is slightly compressed from above using a cylinder,
so that the upper bag flap does not protrude over the edge of the box and the two at the same time
Dust flaps of the box smashed in.
In the further process, glue is applied and the front flap is shaped and glued.
At the end of the cycle chain, the finished box is placed on an outfeed conveyor to the left in the direction of travel
pushed off and transported out of the machine.
power max. 24 boxes / min (depending on processability and size of the cutting material)
Dimensions / weight L x W x H: approx. 3,900 x 2,100 x 2,250 mm