Homag Optimat KL25/7/A12/30
AMERICA North (USA-Canada-Mexico)
- A double sided Homag edgebander.
- 2 X 6 coil tape dispenser
- 1 powered plus 6 idle pressure rollers
- 2 X end trim units each with 2 saws adjustable for first or second run
- 2 X top and bottom rough trim motors
- 2 X top and bottom fine finishing motors with servo motors for adjusting for 1st or 2nd run
- 2 X 4 motor corner rounding
- 2 X top and bottom profile scrapers
- 2 X top and bottom glue scrapers
- 2 X top and bottom buffers
- 2 face sander
- A chip belt to remove end trims etc...
- Barcode software
- a network card
- Panel pre-heating for panels up to 45mm
- Working width increased to 3,000mm
- Approximately a Cdn $40,000.00 rebuild is required by Homag to give a 100% like new operation. (Estimate available)