Holzfraese HP 1890
EUROPE (Western and Northern)
Used machine
only 110 operating hours!
Equipment and technical data:
X = 1800mm
Y = 900mm
Z = 80mm
in 18 mm Koskisen panels consisting of a milling table (X-axis), a portal (Y-axis) and a Z-axis.
Milling bed in 19 mm MDF as a sacrificial plate with guide rails and slot blocks, as a clamping method.
Base frame with struts, filled with polymer concrete, prepared for transport by pallet truck or forklift.
Mechanics set consisting of profile guides including guide carriages, as well as ball screws 2010 and 1605 for all axes.
Shaft couplings and high-performance grease for lubricating the individual cars, as well as energy chains including connection sets.
Control set consisting of a Triple Beast, for controlling 3 axes, with Ethernet connection.
Leadshine power amplifier for the fourth motor.
Four stepper motors, 5.0A, 3Nm with motor cables, as well as a switching power supply
with 48 V, 6.7 A, LED board for breakout board, ribbon cable and proximity sensors,
small parts such as wire cables, wire end sleeves, control cable, shrink tubing and cable lugs.
Ready installed in an aluminum housing including electrical kit and emergency stop.
21.5 inch monitor as a built-in monitor, including mini PC with Windows 7
CAD software Rhino 5.0, G-Code generator Estlcam, control software Beamicon2,
as well as mouse and keyboard, pre-installed in an ergonomic desk.
Tool length sensor for determining the length and changing the active zero point offset.
Special equipment:
High-frequency spindle with 2.2 kW, including union nut, frequency converter, line filter, braking resistor and collet set.
PC with 8 GB of RAM and AMD processor
CAD software Rhino 5.0 for creating both simple 2D data and 3D solids
Incl.
-10-piece cutting tool set:
1 piece 6 mm solid carbide double cutter
1 piece 5 mm solid carbide double cutter
5 pieces 4 mm VHM single cutter
2 pieces 1.5 mm solid carbide double cutter
1 piece VHM engraving cutter 30 degrees
-Special equipment:
High-frequency spindle with 2.2 kW, including union nut, frequency converter, line filter, braking resistor and collet set.
-Assembly, commissioning and instruction
-Assembly of a side channel compressor