Hofmann TFS 107 Milling machine

Swivel table milling machine with CE equipment
– Table size 1,200 x 815 mm, heavily ribbed cast iron table, finely planed; machine height 890 mm
– Table rings 262/220/160/115 mm;
– Tool 250/200/140/100/65 mm
– Permanently installed milling spindle (not interchangeable) with milling mandrel
– 30 mm including quick-release nut “fix” (for quick, convenient tool changes – without spindle blocking), clamping length 140 mm
– Electric height adjustment of the milling spindle 145 mm in rapid and creep speed, LED display at 1/10 mm, with switchover option
– Absolute dimension/incremental dimension
– Electric swivel adjustment of the milling spindle from -45.5° to +45.5° in rapid and creep speed, LED display at 0.1°
– 4 speeds 3,000/4,500/6,000/9,000 via stepped pulley,
– Speed ​​display
– Electronic start and brake device
– Left/right rotation, right rotation via two-hand operation with Warning display
– Switch panel clearly integrated in the machine stand
– Milling stop type 2601 Efficient. Overall adjustment via handwheel according to digital counter and fine adjustment of the inlet jaw
via cylinder knob according to scale to 0.1 mm with multiplex stop jaws
(after lifting the stop, the entire table is freely available  after reassembly, no reference run needs to be carried out)
– Machine socket CEE-16A6h secured with plug for feed device. On/off button for this in the switch panel
– Machine low maintenance
– 2 suction nozzles 120 mm  on the stop and below the table.
Air speed 20 m / sec.
– Electrical equipment in accordance with VDE/EN 60204 and EN848-1 with main switch, emergency stop button,
motor protection and winding protection, undervoltage protection, contact for controlling the extraction
– Accessories: HOFMANN milling protection “Centrex”,
curved milling protection TAPOA for milling on the thrust ring with
extraction nozzle, operating tool, grease gun, operating instructions
– Paint finish: grey white, signal blue, white aluminum
– Weight: approx. 850 kg

Additional equipment:
# 5027
Milling stop type 2620 (instead of standard stop type 2601 Efficient)
Total adjustment via handwheel after

– LCD display
– Option to switch to tool zero dimension
– Mechanical digital display for individual jaw adjustment
– Double-guided stop with larger clamping surface for the stop jaws
– Double clamping
– Including quick-clamping system for the stop jaws
– Stop adjustment to the center of the milling spindle
– After lifting the stop, the entire table is freely available
– After reassembly, no reference run is required

# 5055
Integral stop plates 650/650 mm, instead of multiplex

# 50096
Console for feed device

# 50131
Safety light bar on the milling stop
Warning lights on the stop light up when the spindle is running
Eumacop feed EVS 48 including stand plus
4 – roller, 8 speeds