GE (General Electric) AKTA Explorer 100 FPLC Pred Avant

GE / Amersham AKTA Explorer 100 FPLC Pred Avant Unit5

Predecessor to:
AKTA avant

Condition:
This GE AKTA Explorer FPLC system is in good working order.

Please see the exact video and photos below.

Testing we performed:
The GE AKTA Explorer FPLC system passed all tests and was found to be fully functional:
The following onboard tests were performed to the main components (P-900 pump / UV-900 detector / pH/C-900)
Prom test: PASSED
RAM test: PASSED
EEPROM test: PASSED
Display test: PASSED
Key test: PASSED
Dial test: PASSED
Uninet 1&2 test: PASSED
Buzzer test: PASSED

Extended testing for UV-900
Block filter test: PASSED
Digital inports test: PASSED
Lamp intensity test: PASSED
Light intensity test: PASSED
Noise test (10 loops): PASSED
Stepper motor test: PASSED
Dark current test: PASSED
Motor stress test: PASSED

Extended Testing for Pump-900
Variable flow tests up to system maximum/minimum: PASSED
Pressure test / Pressure alarm: PASSED

Extended testing for Sample Pump
Pressure: PASSED
Flow: PASSED

System consists of:
AKTA Explorer 100 System including:
Box-900
P-900 Pump w/100 Pump heads
UV-900 Monitor
pH/C-900 Monitor
P-960 Sample Pump
M-925 mixer with 0.6mL Mixing chamber
IV-908 motor valve
(2) INV-907 motor valve
(4) PV-908 motor valve
CU-950 Control Box
Frac-950 Fraction Collector w/ 128-Tube Rack A (18mm and 30mm tubes)
(2) 3-port switch valves
Dell Latitude i5 running UNICORN software ver5.11

Communication and power cables.

PLEASE NOTE: PH PROBE IS NOT INCLUDED. IT MIGHT OR MIGHT NOT BE NEEDED FOR YOUR APPLICATION.

Configuration and Setup:
P-900 pump flow rate: 0.01-100ml per minute
UV/vis - pH - conductivity
Software: UNICORN version 5.11
Fraction collector: Frac-950
Accessories: P-960 sample pump, M-925 mixer w/ 0.6ml mixing chamber, Conductivity sensor, UV sensor, Two switch valves (3 ports)

Video Description:
We zoom out so a full view of the entire GE AKTA Explorer FPLC system can be seen. From here we zoom into the main stack components and cycle through several menus.
The CU-950 is seen next front and back followed be the laptop where connection, functionality, and software versions can be seen.
From here we pan over to the pump heads and switch valves before moving to flow cells and then the motor valves on the door.
Fraction collector is seen next and then we pan around to the rear of the GE AKTA Explorer FPLC system so that all serial tags and connections can be seen.
Once we've seen the whole GE AKTA Explorer FPLC system we return to a front view.