Daco DTD 250

Used 250mm (10-inch) bench-top rotary die cutter
Unwind (maximum unwind diameter: 450mm/18 inches
Merobel electronic clutch
Controller and load cell, 76mm/3 inches air mandrel)
Splice table, 2 rotary die stations (1st rotary die station with cutter repeat lengths: 153-406mm (6” – 16”) repeat
Gearing 1/8cp 20 degree pressure angle
Removable anvil; prepared to accept waste stripping at a later date
2nd rotary die station with matrix rewind
Cutter repeat lengths: 153-406mm (6” – 16”) repeat, 76mm/3 inches mechanical mandrel for matrix rewind
Maximum matrix rewind diameter: 400mm/15.75 inches, gearing 1/8cp 20 degree pressure angle, and removable anvil)
Twin product rewinds (2 x 76mm/3 inches air mandrel, labels in / labels out rewinding
Pneumatic rewind clutches with independent regulator & gauge
Top rewind shaft rewind diameter 14inches/360mm
Bottom rewind shaft rewind diameter 9 inches/230mm

Note:
When both shafts are used together the maximum rewind diameter is 9inches/230mm)
Maximum web speed: 150 meters/min (492 feet/min) dependent on stock
Count units: labels / meters with programmable slow down & stop
Rotary scissor slitting unit (3 slitting knives, removable interlocked cutter guard
Minimum slit width: 16mm/0.62 inch
Lateral knife adjustment: +/- 8mm/0.31 inch)
Adjustable silicone nip roller running against a driven draw roller with its own motor
Rotometrics RD scorer with 2 holders – extra rollers to allow face and back scoring.
Electrical requirements: 240 volts, single phase, 13 amps.
Air requirements: 80 psi, 1cfm – 6mm air fitting.
Workbench included.