CM&E, Schurman 4TA24/Model 34 Chipping Edge

One (1) Used Chipping Edge
Infeed Table -26-long with seven (7) 8-1/2" x 36" knurled and chromed table rolls, six (6) jump chains,
parking ramps, shifting straight edge, board turners, and feeds from right side, if facing infeed end of system.

Infeed Module -4" x 36" capacity, with two (2) powered knurled and chromed
press rolls, two (2) knurled and chromed powered bedrolls, driven
by 7-1/2 HP SM cyclo-drive, laser box, and over thickness bar.

Chipping Module - One (1) CM&E Model 34,
8-knife, bent knife chipping head mounted on right side with sliding base,
150 HP Toshiba TEFC motor, (one 150HP motor missing) temposonics
controlled hydraulic linear positioner cylinder, automatic bedway lubricator,
shroud, v-belt drive, guards, and chromed bedplates.
Chipping head on left side is same as right, but is stationaryand is missing motor.

Saw Module - Schurman Model 4TA24 saw box,
with shifting saw arbor without motor, with two (2) chromed
smooth non-powered press rolls, three (3) knurled and chromed powered bedrolls,
25 HP SM cyclo-drive, and temposonics controlled hydraulic linear positioner cylinder to control location of splitter saw.

System appears in good condition, with all rolls and other wear parts showing little or no use but has been sitting idle since 1997.