Bobst NOVACUT 106E

N.of Impressions 31
Centerline system for quick job changeover
Bobst-Electronic machine operating system CUBE 3 (Control Unit Bost Electronic) with color touch screen
Main motor with frequency converter control
Table feeder with upper frame with manual lifting device
Feed table with transport belts (with lateral guidance and automatic tensionning system)
Pile tray wit handle allowing manul lateral correction of the pile during production
Pile lifting controlled by pressfoot
Real pile guides (OS and OOS)
Synchronization device timing the sheet arrival against the front lays when the machine is at a standstill
Side blowers adjustable with Centerline marks
Suction unit
Safety system for lowering the pile tray
Feed table covered with an anti-static stainless steel plate
Feed table inlet equipped with lateral ramps
Feed table with support plates at entry of platen station
Feed table with 4 front lays, adjustable in pairs with front register control
Feed table with Pull guide (OS) adjustable according to Centerline marks, with side register control
Feed table with double sheet detector. Mechanical, integrated on pull guide (OS)
Feed table sheet-hold down device (guiding the sheets to front lays)
Feed Table with upper transport equipment for paper, paperboard and corrugated board
Measurement of the cutting force with strain gauge on platen
Adjustable centering at stripping station
Gripper reopening device on platin
Equipment centering and locking on platin
Automatic locking of the chase against the upper beam on platen
Synthetic material supporting plate on platen (Thickness 23.5 mm (0,925)
Quick locking device of the central stripping board on Waste Stripping Station
Motorized lifting of the upper frame on Waste Stripping Station
Non-stop delivery with grill
Pile tray in delivery
Front jogger in delivery
Adjustable rear and side joggers with Centerline marks in delivery
Braking Brush in delivery
Electronic device for sheet travel control
1 Lower stripping pull-out frame (T.230.001)
Control cabinet cooling unit
1 Cutting plate (T-120.001) Thickness 5 mm
1 Upper stripping equipment (T-205.001) Equipment required to create a waste stripping tool,
including crossbars, clamps, stripper holders and stripping pins of 3, 5 and 10 mm of diameter
1 Upper stripping pull-out frame (T-200.001)
1 Fastening equipment for stripping die (T-205.002) Including crossbars and clamps
1 Adaption material for stripping board on the central frame (quick locking) (T-225.002)
1 Lower stripping equipment (T-235.001) Equipment for waste stripping including crossbars, pins and supports